Audionet ART G3 Manuel d'utilisateur télécharger pdf (Page 10)

Important

· The electrical specifications of your home country must meet the

electrical specifications printed onto the back panel.

· The ART G3 is a Class I unit and must be earthed. Please ensure a

stable earth connection. 'Phase' ('hot' pin) is marked on the back panel

('PHASE') 13 .

· Never pull the mains plug while the ART G3 is switched on! Always

power down the unit to stand-by mode first, before you pull the

mains cord from the mains input 12 on the back panel of the unit.

Wait at least 3 minutes before you re-plug the unit to mains.

Only in case of extended absence (like vacations) or if massive trouble on

the mains power is to be expected you should disconnect the unit from

mains. To disconnect the ART G3 completely from mains pull the mains

plug.

4.3 Orientation of mains plug

The correct polarization of mains is important for reasons of audio clarity

and stability. Please connect the mains cord that the hot pin of the wall

outlet is connected to the pin of mains input 12 marked 'PHASE' 13 on

the back panel of the unit. Your Audionet ART G3 is able to detect a

wrong polarization of the mains plug during start-up. If the message

► Attention: ◄

► Mains Phase incorrect ◄

appears in the display, switch off the unit and flip the mains plug in the

wall outlet (refer to section 'Mains phase detection' on page 24).

4.4 Connecting the external power supply EPS or EPX

To use one of the optional external power supplies EPS or EPX with your

ART G3 follow these steps:

1. Make sure both ART G3 and EPS / EPX are switched off and

disconnected from the mains.

2. Connect the EPS / EPX with the included cable to input jack 8

on the back panel of the ART G3. The shape of the plug prevents

any wrong polarity. The small 'nose' inside the plug has to face

upwards. Now screw the ring of the plug onto the input jack 8 .

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 53 54

Pas de commentaire

Audionet ART G3 Manuel d'utilisateur Page 10